-
Rivers Raymond posted an update 1 year, 5 months ago
HDPE waterproofing membrane products perform congrats of keeping your house dry and tidy, it’s one of many good solutions for leaking houses because it is affordable, it’s low maintenance, and it’s very convenient.
Whether it’s a leaking roof or a room leaking to another level of occupants, it can damage to property as well as neighborhoods. This is the ubiquitous architectural phenomenon, along with construction, leaking water may be the second biggest overuse injury in building quality. Now, a lot of people have taken measures, waterproof coatings, waterproof membranes, and other products.
What are HDPE damp membranes?
HDPE damp membranes are actually a self-adhesive waterproof material, that has the options of superior performance, warm resistance, and sturdiness. In addition, the self-adhesive film includes a polymer adhesive layer.
HDPE damp membranes are constructed of high-quality high-density polyethylene resin, at the same time, ultraviolet absorbers, anti-aging agents, etc. will also be used.
Features of HDPE waterproof membrane
Durable
Long-lasting
Less maintenance
Supports construction on wet bases
Simple to construct
Castable skeleton steel bar
It might form a super-strong bond with concrete, thus preventing the penetration of rain and moisture
Prepared to walk
Following your waterproof layer is fully gone, it can be directly tied to the effect resistance of reinforced concrete without a protective layer
Low requirements to the lower layer, and could be constructed on uneven and wet base surfaces
Not suffering from objective factors, thereby reducing construction costs
More flexible construction methods
Good waterproof performance
Widely application
Whether it’s the top the main ramp, the waterproofing of the tunnel, along with the pool, it can be perfectly waterproofed. Concurrently, HDPE damp membranes bring high-requirement waterproof projects and a few gas leakage prevention.
Installation tips
Maintain your base layer clean first. If your sharp part of the protrusion is available, it will be processed to be flat. In case there are more water stains, keep the lower layer moist.
Unroll the membrane. When laying the show on the base layer, you need to observe the particles with the film facing up, as well as the edges of the adjacent films should be aligned to stop overlapping.
How to determine the thickness with the film meets the requirements?
This process is very brief, please take a needle and randomly select 3 points per 100 square meters for the membrane for penetration experiments. Dimensional measurements were created for that thickness of the 3 needle punches respectively, lastly, an average value was taken for his or her heights. If your average thickness is bigger than 1.5mm, it meets the requirements.
To read more about màng chống thấm hdpe explore our webpage